Farmhouse Benches- Guest Blogger! Tommy Sibiga

| October 13, 2011 | 1 Comment

Farmhouse Bench

Due to the overwhelming demand and positive feedback about Tommy Sibiga’s ‘Farmhouse Table’ guest blog, found here, we are excited to announce that Tommy will feature a few more guest blog posts for ForRent.com! Tommy’s guest posts will be featured every other Thursday until November 10th. Enjoy!

 

 By Tommy Sibiga

Follow Tommy and Ellie on their blog at Our Con{temporary} Home

 

Do you know how much dining room chairs cost? Take that number and then multiply it by 12. What do you get? A very large number. A number that’s well beyond our means.

 

When I first started considering to build a dining room table, I researched how expensive dining room chairs would be to go along with our table. I was pretty shocked when I found that all the chairs that we liked ranged between $70 to $100 a piece. Our goal was to have the ability to seat 12 comfortably and so that total cost quickly shot up to $840 to $1200. Wowsa!

 

With the high cost of dining room chairs in mind, I needed to pick out a table design that I could also incorporate into a bench design to decrease the total number of chairs that we would need to buy. That was one of the big criteria in choosing the farmhouse design from the get-go. Once again, I came across the idea/inspiration/building plan from ana-white.com. Here’s the building plan; http://ana-white.com/2011/01/farmhouse-bench

 

Unfortunately, I was so wrapped up in all of these building projects that I didn’t take any during pictures. My apologies. The bench was a very similar process to the Farmhouse Table, found here.

 

I started with the 4×4”s that were going to become the legs of the bench. They were leftovers from the 8’ lengths that I used to build the dining room table. I cut them down to 16.5” and began to notch them out. To do this, I set my table saw blade to a height of 1.5”, I ran them through the table saw making my first cut at 3.5” from the bottom, my second cut at 7” from the bottom, and then a bunch of tiny subsequent cuts anywhere in between that range. I then hammered out the little slivers and swirled it all around the table saw to smooth it out.

 

 

One major difference between the bench and the table is that I used a 2×4” as the stretcher instead of a 4×4”. You can notice the difference if you look closely at this picture but it’s a small enough difference that you wouldn’t be able to tell when you’re in the room.

 

Since the table top included 4 planks, I decided to use 4 planks on the bench….but instead of using 4-2×12”s, I used 4-2×4”s. I used my Kreg Jig and a bunch of clamps (I love clamps) to join the bench top together. The rest of the steps were simply cutting things to length, running them through the planner, rounding off the edges, and a small dose of distressing. I then clamped it all together and using some hidden pocket holes, tightened everything up. It was stained to match and instead of using the Briwax to finish it off, I put a couple coats of Polyurethane on it. The overall dimensions are 72”l x 14”d.

 

Just a reminder to check back every other Thursday to get your DIY on. You can also check out more of Tommy and Ellie’s blogs at our con{temporary} home.

 

 

Tags: , , , , , ,

Category: Apartment Life, Contests, Guest Blog

Comments (1)

Trackback URL | Comments RSS Feed

  1. Dallas TX Apartments says:

    Helpful and inexpensive. My uncle and relatives in Kansas will probably be thrilled to see this post, so I sent it to them already. I hope they enjoy it! Thanks for the blog.

Leave a Reply




If you want a picture to show with your comment, go get a Gravatar.


5 − = one